First plug the radio in and turn it on (switch on right side)

At any time you can press MENU to back out of the menu.

Menu wraps around….TIME, ALARM, CHANNEL, SAME SET, ALT TYPE, ALT TEST and LIGHT.

SET TIME

(If you want to skip this menu press UP arrow to skip to next menu)

Press MENU--- “TIME” is displayed

Press SELECT---Hours will flash

Press UP/DOWN arrows to set the hours

Press RIGHT arrow--- 10’s of minutes flash

Press UP/DOWN arrows to set the 10’s of minutes

Press RIGHT arrow--- Single minutes flash

Press UP/DOWN arrows to set the minutes

Press SELECT--- Time is now set

SET ALARM

(If you want to skip this menu press UP arrow to skip to next menu)

This sets the alarm clock…. Skip this menu.

SET CHANNELS

(If you want to skip this menu press UP arrow to skip to next menu)

Press UP arrow--- “CHANNEL” is displayed

Press SELECT---Radio comes on so you can hear the broadcasts

Press the UP arrow to select a channel in your area (See attached sheet for TX in your area)

Press SELECT to set the station

SAME SET

(If you want to skip this menu press UP arrow to skip to next menu)

Press UP arrow--- “SAME SET” is displayed

Press SELECT---“ANY” is displayed

Press UP arrow to select “SINGLE”, MULTIPLE” or “ANY”. SINGLE is for 1 county only, MULTIPLE is more that 1 county and ANY is for all counties

Press UP arrow to select “SINGLE” for now

Press SELECT--- “SAME 01” is displayed

Press SELECT--- “00 00 00” is displayed. First 0 is flashing

Press UP arrow to select first digit. See attached sheet for county codes

Press RIGHT arrow to move to next digit

Press UP arrow to select next digit

Repeat for all 6 digits

Press SELECT when all 6 digits are entered. “SAME SET” is displayed. If you had selected MULTIPLE the display would say “SAME 01” You would press the UP arrow to set display to “SAME 02” to set the next county code. Repeat for next county

ALERT TYPE

(If you want to skip this menu press UP arrow to skip to next menu)

Press UP arrow--- “ALT TYPE” is displayed. (This is the alert type)

Press SELECT--- “TONE” is displayed

Press UP arrow to select “TONE”, “DISPLAY” or “VOICE”. TONE sounds alarm tone, DISPLAY is display Only no tone, VOICE is radio announcement only

Press SELECT to set alert type

ALERT TEST

(If you want to skip this menu press UP arrow to skip to next menu)

Press UP arrow--- “ALT TEST” is displayed. (This is to test the alarm tone)

Press SELECT--- The alarm sounds…. Press VOLUME UP/DOWN to stop alarm

LIGHT

(If you want to skip this menu press UP arrow to skip to next menu)

Press UP arrow--- “LIGHT” is displayed. (Leave this menu alone, it’s OK where it is)

Press Menu--- You are done programming the radio